From monitoring it is possible to enable the NetFlow protocol on the portgroup. Once enabled, you can configure the NetFlow collection IP address and TCP […]
Back to Basics: Health Check (5 of 9)
Health Check allows vSphere to analyse the attributes of the Distributed Switch, and compare them to the attributes of the physical switch. It can be […]
Back To Basics: Private VLAN (4 of 9)
You know the more I get back into Distributed Switches – the more this is looking like a 10/20/30 part series…! This part concerns Private […]
Back To Basics – Migrating to Enhanced LACP (Part 3 of 9)
Introduction Recommendation: If you are intend to use LACP consider deploying from day one rather than migrating from Distribute Uplink containers. The migration is simple […]
Back To Basics: Managing Properties of Distributed Switch (Part 2 of 9)
Wooo-weee. Aren’t there a lot of settings and options on both Distributed Switch and the Portgroup. It can feel a bit daunting if its the […]
It’s the most wonderful time of the year…
Yeah, I know – totally now unseasonal and inappropriate blogpost title. It’s that time of year when Eric Siebert starts the voting process for Top […]
How to get a broken server door key out of HP ML350e
Yes, I know how esoteric and specific can a blogpost get, eh? I’d only had my new HP ML350e series servers in a homelab until […]
Back To Basics: Managing a Distributed vSwitch (Part 1 of 9)
Well, its the start of a new “chapter” in the Back To Basic series. This time focusing on networking. Hang on I hear you say, […]
Hyper-V R2eality: VMs not so hot after all…
When I first got into virtualization with VMware, one of the most compelling advantages was the fact that the VM is just a process (albeit […]
Return to the homelab (Part 4)
If you have been following this series of posts for a while. You’ll know I have an issue with my new HP ML350e Gen8 servers. […]